NZ = 1;      % number of ZEROS in the filter to be designed
NP = 4;      % number of POLES in the filter to be designed
NG = 10;     % number of gain measurements
fmin = 100;  % lowest measurement frequency (Hz)
fmax = 3000; % highest measurement frequency (Hz)
fs = 10000;  % discrete-time sampling rate
Nfft = 512;  % FFT size to use 
df = (fmax/fmin)^(1/(NG-1)); % uniform log-freq spacing
f = fmin * df .^ (0:NG-1);   % measurement frequency axis

% Gain measurements (synthetic example = triangular amp response):
Gdb = 10*[1:NG/2,NG/2:-1:1]/(NG/2); % between 0 and 10 dB gain

% Must decide on a dc value.
% Either use what is known to be true or pick something "maximally
% smooth".  Here we do a simple linear extrapolation:
dc_amp = Gdb(1) - f(1)*(Gdb(2)-Gdb(1))/(f(2)-f(1));

% Must also decide on a value at half the sampling rate.
% Use either a realistic estimate or something "maximally smooth".
% Here we do a simple linear extrapolation. While zeroing it
% is appealing, we do not want any zeros on the unit circle here.
Gdb_last_slope = (Gdb(NG) - Gdb(NG-1)) / (f(NG) - f(NG-1));
nyq_amp = Gdb(NG) + Gdb_last_slope * (fs/2 - f(NG));

Gdbe = [dc_amp, Gdb, nyq_amp]; 
fe = [0,f,fs/2];
NGe = NG+2;

% Resample to a uniform frequency grid, as required by ifft.
% We do this by fitting cubic splines evaluated on the fft grid:
Gdbei = spline(fe,Gdbe); % say `help spline'
fk = fs*[0:Nfft/2]/Nfft; % fft frequency grid (nonneg freqs)
Gdbfk = ppval(Gdbei,fk); % Uniformly resampled amp-resp

figure(1);
semilogx(fk(2:end-1),Gdbfk(2:end-1),'-k'); grid('on'); 
axis([fmin/2 fmax*2 -3 11]);
hold('on'); semilogx(f,Gdb,'ok');
xlabel('Frequency (Hz)');   ylabel('Magnitude (dB)');
title(['Measured and Extrapolated/Interpolated/Resampled ',...
       'Amplitude Response']);